1970-1981 Camaro & Firebird Suspension Stage Packages

STAGE 1:
Pro Touring IFS
• Complete tubular bolt-in front clip
• Ridetech single adjustable coil-over shocks
• Black powder coated springs
• Bolt-in multi position transmission mount is included
• Greasable urethane bushings
• 1” Performance anti-roll bar
• 1⅛” x .156w U.S. DOM steel lower tubular A-arms
• 1” x .156w U.S. DOM steel upper tubular A-arms
• Power rack and pinion
• Spindles (2” drop or stock height)
• Small block engine brackets
• 11” Slotted zinc plated rotors
• Big bore calipers (with 20% better clamping force)

Torque Arm Rear Suspension
• Ridetech single adjustable coil-overs shocks
• 1¼” High performance link bars
• 1¾” Torque arm with slider & reinforcing flanges
• 1½” Coil-over crossmember with channel brackets (for use
with DSE mini-tubs)
• 1” Adjustable Panhard bar with LH & RH rod ends
• Adjustable pinion support tubes with rod ends with tabs
and install tool
• Axle housing brackets with torque arm tabs and install tool
• 1¾” Crossmember with drive shaft loop
• 1¾” Sub-frame connectors
• Rear anti-roll bar kit (plain)
• Bolt-on trailing arm channel brackets
• Floor reinforcing plates and hardware
• Greasable urethane bushing

Complete 9” Rear End
• Currie round back housing with late/large
Ford bearing flanges (width of your choice)
• All TCI suspension bracketry installed and
fixture welded
• Nodular 3rd member with your choice of new
gear sets ranging from (3:00 to 4:56)
• 31 Spline axles with new tapered bearings,
seals and axle studs
• 12” Hi-Tech rear disc brake kit (GM caliper)
• Axle brackets fully welded
• 1350 Yoke
• Your choice of 4.5” or 4.75” bolt circles
• Open Differential
• Gear oil

STAGE 2:
Same as Stage 1 with
• Upgrade to 12” Wilwood drilled/slotted rotors & 4 piston calipers
• Upgrade from Open Diff. to TwinTrac (gear type) Posi

STAGE 3:
Same as Stage 1 with
• Upgrade to 13” Wilwood drilled/slotted rotors and 6 piston (front) & 4 Piston (rear) calipers
• Upgrade from Open Diff. to TwinTrac (gear type) Posi
• Upgrade from the round back 9” housing to a Fabricated 9 (F9)
• Upgrade from 31 spline to 35 spline
• Upgrade to nodular iron race case & aluminum big bearing support